Steel rules are essential measuring devices in any workshop. The properties of metal allow a worker to score along the edge of the ruler without any fear of damaging the rule itself, a common problem with wood or plastic rulers. Metal rules have been used for the marking out of sheet metal for many centuries and it is therefore unsurprising that examples exist that are marked up to show they belong to the military. The RAF especially relied on fitters and mechanics to keep aircraft serviceable, right form its inception. These men needed extensive tool kits and amongst these would be a steel rule. Tonight we have an Air Ministry marked example to look at:This 6” rule is stamped with the crown and AM mark of the Air Ministry and has a date of 1939:Dating from the 1930s, this rule is predominantly set up to measure fractions of an inch, however the reverse does have a metric scale as well:The use of a steel rule was viewed as so important that the US actually produced a thirteen minute training film on its use for metal workers! This film can be seen here.
The role of the aircraft fitter was essential to repair aeroplanes and get them back into the sky. John Morris served as a groundsman in World War Two:
Each transport took us to the aerodrome which was about 5 miles from Setif, it was the French Air force and had one or two hangars in which to work on the aircraft. Aircraft were brought to the unit when they had flown a large number of hours, which was called a major inspection. They would be jacked up on large metal jacks in what was known as rigging or flying position, the engines were removed, petrol tanks dropped, hydraulics checked, metal replaced with rivets between the engine nacelle and the fuselage where heavy boots walked over the wing when re-fuelling, the metal got stretched. When all of this had been done, the aircraft was re-sprayed, placed in a pool ready for the next squadron that required a replacement aircraft. It was mainly Bristol Beaufighters that were worked on. A twin-engine, two crewed night fighter, fitted with radar, later used for anti-shipping. It was also converted to carry a torpedo or eight 60 lb. rockets.
One repair job I shall always remember was a Beaufighter that had been built with countersinking too large and the rivets sunk below the level of the outside skin. Two of us replaced a thousand oversize rivets making the fuselage smooth. Later it was mentioned that this aircraft had gone out with other planes from the squadron and pumped 55 rockets into the Rex, a 55,000 ton Italian liner just below the water line and sinking the ship just off Trieste.