3″ Mortar Team in Mandalay Photograph

This week’s photograph is a rather nice action shot of a 3” mortar being fired:SKM_C284e18070313140 - Copy (3)This image is marked ‘Mandalay, Burma, 1945’ on the back and is probably either staged for the camera or taken during training as the mortars are not dug in and the camera man would be very exposed in this position if they were being fired in anger. In the centre of the photograph is the 3” mortar itself:SKM_C284e18070313140 - Copy (3) - CopyOne of the crew can be seen having just dropped the bomb into the tube, indeed the bomb can be seen half way in the barrel:SKM_C284e18070313140 - Copy (5) - CopyThe second crewman is kneeling next to the weapon:SKM_C284e18070313140 - Copy (4) - CopyA set of cardboard ammunition tubes for the bombs is on the ground a short distance behind them:SKM_C284e18070313140 - Copy (7) - CopyA second mortar team is in the background:SKM_C284e18070313140 - Copy (8) - CopyAs is a Bren gun carrier:SKM_C284e18070313140 - Copy (6) - CopyThe following detailed description of the 3” mortar comes from ‘Militaryfactory.com’:

The design was characterized by its major components – namely the launch tube, baseplate, bipod, sighting equipment and ammunition. The system was 81mm (3.2″) in precise caliber (despite the 3″ used in the official designation)) and cleared to fire a standard High-Explosive (HE) projectile as well as smoke and illumination rounds. The mortar measured in at 1.295 meters long while the barrel made up 1.19 meters in length. When made ready to fire, the system weighed in at 126 lb while, when broken down for transport, the weapon required at least three personnel – each charged with transporting one of the major pieces into combat. The weapon’s elevation as limited from +45 to +80 degree angles of fire and traverse was 11-degrees in either direction. Elevation and traverse controls were mounted on the bipod assembly while the sighting device was identified along the barrel, towards the muzzle end. The 81mm projectile weighed in at 10 lb apiece.

Operation was conventional with personnel sighting the weapon against the intended target area. One member then dropped the ready-to-fire projectile in through the muzzle to which the projectile fell down the launch tube and struck a firing pin at the baseplate, igniting the internal charge propellant. This explosion forced the projectile out of the tube and along a rudimentary flight path. Crews could then revise the traverse and elevation based on where the previous round fell and repeat the process all over again. The heavy baseplate served to retard the inherently violent recoil of such a weapon while also serving as a third support leg in conjunction with the bipod assembly. As an “indirect fire” weapon, the object of the mortar was to target areas as opposed to individual enemy forces. Its High-Explosive projectiles were very useful against concentrations of enemy personnel. Smoke rounds could be used to shield friendly tactical movements while illumination rounds were used in low-light settings to mark enemy positions.

Typically, the 3-inch mortar system was carried into position by mortar team personnel but it was not uncommon for the British Army to make use of their nimble little “Universal Carrier” tracked vehicles in transporting the weapon at speed (note that the 3-inch mortar was not designed to be fired from the vehicle itself and had to be unloaded and setup to fire on the ground). This speedy transport allowed mortar teams the capability to reach a given area quickly, complete with ammunition supply in tow, and disembark to setup the mortar and make it ready to fire. A crew could also dig out the surrounding land and create a ground depression from which to fire from, providing the crew with basic protection from enemy return fire. So long as the ammunition supply was forthcoming, the mortar team could supply a steady rate-of-fire over the heads of friendly troops

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.