Post-War 37 Pattern Water Bottle Carrier

The 37 pattern webbing set is very much associated with the Second World War, however its story does not end there and it was to see front line service for another two decades and continue being used by reservists and cadets for over forty years. Some changes were made to post war production, such as the fitting of quick release tabs to the ammunition pouches, however one of the most obvious changes was the move from brass to blackened fittings on the webbing. Tonight we are looking at an example of the water bottle carrier dating from the 1950s:imageAlthough the sleeve carrier had been produced during the war to save manufacturing costs, once in peacetime the skeleton design of carrier resumed production, being made up of criss-crossing strips of webbing:imageIt might be helpful at this point to remind ourselves of the official description from the fitting instructions:

Waterbottle Carrier- Consists of a framework with tabs at the top fitted with a snap fastener for securing the bottle, and a buckle each side for attachment to the ends of the braces (when desired).

In design then the carrier matches pre-war production. The difference comes with the buckles which instead of being made of brass are made of bonderised steel which give them a distinctive matt-black finish:imageBonderisation is a chemical process where steel is passed through a phosphate solution, this leaves a layer of crystalline zinc phosphate on the surface of the metal that prevents corrosion and gives the metal its dull black finish. This has the advantage of being far cheaper than the old brass fittings, but not rusting like a pure steel buckle would. Clearly the finish was only suitable for flat stampings such as buckles as the press stud on the top of the carrier is made of brass, but enamelled black:imageThe webbing with a blackened finish was given a special stores code to distinguish it from the older webbing, either CN/B/XXXX or CN/XXXX/B. The webbing code is stamped on the inside of the water bottle carrier in black ink:imagePost war 37 pattern webbing is largely ignored by collectors as it is unsuitable for World War Two impressions and collectors seem to have a natural bias towards that conflict. Consequently post war 37 pattern webbing with black fittings is considerably cheaper than webbing with brass fittings and is usually found in near-mint condition. Going forward I would quite like to build up a set of this bonderised webbing and hopefully I can bring you more components as I acquire them.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.